03-15-2007 10:08 AM - edited 03-05-2019 02:56 PM
Hi all, can someone help. I have a setup, using a asa in transparent mode, switch A goes into inside of asa, then switch 2 plugs into outside of ASA, I have created an allow all rule, BUT i cant see the bpdu's coming through to the other switch, can anyone please help?
cheers
Carl
03-15-2007 10:17 AM
Carl,
Configure the following on your ASA:
hostname(config)# access-list ETHER ethertype permit bpdu
hostname(config)# access-group ETHER in interface inside
hostname(config)# access-group ETHER in interface outside
HTH,Please rate if it does.
-amit singh
03-15-2007 10:22 AM
Hi Amit, I have tried this and it still doesnt seem to work, any ideas why ?
03-16-2007 03:10 AM
Cab anyone help me on this?
cheers
Carl
09-17-2007 07:25 PM
Hi Carl,
Can you share your experience how you solve the bpdu issue on the ASA?
Right now, I'm having the same problem. I have tried using the Ethertype access-list to allow the bpdu, but still cannot. The hit-count on the access-list is not increased.
Thanks a lot for your help.
Regards,
-Adi-
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide