Hi Ivan,
Switch was configured in redundant power mode, we haven't seen any logs from the switch before the reload; but the switch starting sending logs only after the reload and then declared the PS1 as bad.
Would it possible that the switch faced a power jerk/spike and a safety or protection measure it got reloaded, resulting in PS1 getting faulty.
show power detail
Power Fan Inline
Supply Model No Type Status Sensor Status
------ ---------------- --------- ----------- ------- -------
PS1 PWR-C45-1400AC AC 1400W good good n.a.
PS2 PWR-C45-1400AC AC 1400W good good n.a.
Power supplies needed by system : 1
Power supplies currently available : 2
Power Summary Maximum
(in Watts) Used Available
---------------------- ---- ---------
System Power (12V) 579 1360
Inline Power (-50V) 0 0
Backplane Power (3.3V) 40 40
---------------------- ---- ---------
Total 619 1400
Watts Used of System Power(12V)
Mod Model budgeted instantaneous peak out of reset in reset
---- ------------------- -------- ------------- ------ ------------ --------
1 WS-X4648-RJ45V-E 92 -- -- 92 10
2 WS-X4648-RJ45V-E 92 -- -- 92 10
3 WS-X45-SUP6-E 260 -- -- 260 260
-- Fan Tray 135 -- -- -- --
------------------------- -------- ------------- ------ ------------ --------
Total 579 -- -- 444 280
Watts used of Chassis Inline Power (-50V)
Inline Power Admin Inline Power Oper
Mod Model PS Device PS Device Efficiency
---- ------------------- ---------------- ---------------- ----------
1 WS-X4648-RJ45V-E - - - - -
2 WS-X4648-RJ45V-E - - - - -
3 WS-X45-SUP6-E - - - - -
------------------------- ---------------- ---------------- ----------
Total 0 0 0 0
show power status
Power Fan Inline
Supply Model No Type Status Sensor Status
------ ---------------- --------- ----------- ------- -------
PS1 PWR-C45-1400AC AC 1400W good good n.a.
PS2 PWR-C45-1400AC AC 1400W good good n.a.
