02-15-2010 07:38 PM - edited 03-06-2019 09:43 AM
i just removed two switches from my ccie R&S lab but now i has a very strange problem switches is working fine but i can not access from console after boot .
02-15-2010 08:04 PM
Someone must've adjusted the baud settings.
02-16-2010 09:34 AM
Baud rate is 9600 its ok even i can see the console logs but cant work on it.
02-16-2010 08:11 PM
Do you have any other devices you could use to check your terminal emulator is working? I had an issue with hyperterminal once, that it would not transmit following a reboot of the device it was managing. But in my case, re-booting the PC (with a proper power cycle) cleared the problem, so it couzld have been something to do with flow control.
Kevin Dorrell
Luxembourg
06-19-2014 04:48 AM
Hi Khalid,
I am having the same problem with 2960 Catalyst Switch. Switch boots and the booting process shows up on console, but after the boot-up, console Hangs. Did you find the solution for your problem? How did you solve it ?
Thanks
Hassan
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide