Hello,
recently we bought 2 SG200 to expand our network to Gigabit.We own 1 Catalyst 3650.
We tryed to Etherchannel between the Catalyst and one SG200 but with no luck.
At Catalyst i created the port channel
interface Port-channel1
switchport mode access
and put 4 ports on it
interface GigabitEthernet0/45
switchport mode access
channel-group 1 mode on
!
interface GigabitEthernet0/46
switchport mode access
channel-group 1 mode on
!
interface GigabitEthernet0/47
switchport mode access
channel-group 1 mode on
!
interface GigabitEthernet0/48
switchport mode access
channel-group 1 mode on
when i do show interface port-channel 1 i get that
Port-channel1 is up, line protocol is up (connected)
Hardware is EtherChannel, address is 001a.a24d.00ae (bia 001a.a24d.00ae)
MTU 1500 bytes, BW 4000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Full-duplex, 1000Mb/s, link type is auto, media type is unknown
input flow-control is off, output flow-control is unsupported
Members in this channel: Gi0/45 Gi0/46 Gi0/47 Gi0/48
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:16, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 988000 bits/sec, 166 packets/sec
5 minute output rate 1943000 bits/sec, 224 packets/sec
3283827412 packets input, 3257328668 bytes, 0 no buffer
Received 34678609 broadcasts (0 multicast)
0 runts, 0 giants, 0 throttles
10 input errors, 10 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 8423441 multicast, 0 pause input
0 input packets with dribble condition detected
1976995515 packets output, 241528325 bytes, 0 underruns
0 output errors, 0 collisions, 7 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
I can see that the port-channel is 4Gbit but into the SG200 web interface the Link stays at 1Gbit
I also giving you 2 screenshots from the sg200.
Am i doing something wrong?
Do you have any suggestions?
Is able sg200 to create etherchannel with the Catalyst?
Thanks in Advanced
Alex
