01-26-2014 02:23 AM - edited 03-07-2019 05:47 PM
hi ,
i need to setup network teaming and do ethernahcneel between
Catalyst 4006 & Linux server
i want to ask ,
does catalyst 4006 support lacp ???
if dont support lacp , does pagp cant be work if the 2nd side is not a cisco device ?? in my case "linux server "
???
regards
01-26-2014 12:47 PM
The answer to the 2nd question is no you can't use pagp with a non cisco device so that is out. Unless you are running really old catos code then it should support lacp. I believe there were some restrictions on the 4006 on which ports you could aggregate together . Try something like show port capabilities to see.
01-26-2014 07:22 PM
@CSCO12006413
Listen to ‘glen.grant’ – ‘pagp’ is propriety to Cisco devices, so your only option will be ‘lacp’.
However, my question to add to this post – would ‘CSCO12006413’ want to go with the MAC or IP Load-balancing methods? Question - If the destination address is the same, but source address different ‘CSCO12006413’ should use MAC based load-balancing; however, if this is for server-to-server configuration, I think you will want to use IP based load-balancing on the EtherChannel configuration?
Thanks
JJ
01-27-2014 01:30 AM
thanks all
regards
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide