01-17-2014 07:04 AM - edited 03-07-2019 05:37 PM
Hi Community, I have a catalyst 4507R-E and I put this module WS-X4648-RJ45V+E in the 7 slot, but the show module command show me Unsupported, this is the show version and the show module!
? This catalyst 4507R-E whit this Supervisor Supervisor II+ WS-X4013+ suppourt thos module WS-X4648-RJ45V+E ?
thanks Community.
Sw_Core_AECSA#sh version
Cisco IOS Software, Catalyst 4500 L3 Switch Software (cat4500-IPBASE-M), Version 12.2(54)SG1, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2011 by Cisco Systems, Inc.
Compiled Thu 27-Jan-11 11:43 by prod_rel_team
Image text-base: 0x10000000, data-base: 0x11ED6EBC
ROM: 12.2(31r)SGA1
Dagobah Revision 226, Swamp Revision 34
Sw_Core_AECSA uptime is 4 hours, 15 minutes
Uptime for this control processor is 4 hours, 15 minutes
System returned to ROM by power-on
System image file is "bootflash:cat4500-ipbase-mz.122-54.SG1.bin"
cisco WS-C4507R-E (MPC8245) processor (revision 10) with 262144K bytes of memory.
Processor board ID FOppp
PC8245 CPU at 266Mhz, Supervisor II+
Last reset from PowerUp
1 Virtual Ethernet interface
8 Gigabit Ethernet interfaces
511K bytes of non-volatile configuration memory.
Configuration register is 0x2101
Mod Ports Card Type Model Serial No.
---+-----+--------------------------------------+------------------+-----------
1 6 SFP, 10/100/1000BaseT (RJ45)V, Cisco/I WS-X4506-GB-T JA12345
3 2 Supervisor II+ 1000BaseX (GBIC) WS-X4013+ J12345
7 0 Unsupported module WS-X4648-RJ45V+E J12345
Solved! Go to Solution.
01-17-2014 07:30 AM
This catalyst 4507R-E whit this Supervisor Supervisor II+ WS-X4013+ suppourt thos module WS-X4648-RJ45V+E ?
No, your supervisor only supports classic linecards but the WS-4648-RJ45V+E is not a classic line card so it is not supported. Have a look at this link and refer to Table 1 which shows which supervisors you could use with this card -
Jon
01-17-2014 07:30 AM
This catalyst 4507R-E whit this Supervisor Supervisor II+ WS-X4013+ suppourt thos module WS-X4648-RJ45V+E ?
No, your supervisor only supports classic linecards but the WS-4648-RJ45V+E is not a classic line card so it is not supported. Have a look at this link and refer to Table 1 which shows which supervisors you could use with this card -
Jon
01-20-2014 08:36 AM
Thanks, Jon!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide