07-19-2019 10:48 AM
I am new to virtual staking and am not sure what I am missing but any time I enter the command -
Switch(config)#stackwise-virtual
I get Invalid input detected at marker.
Can someone tell me what I am missing?
Solved! Go to Solution.
07-19-2019 10:58 AM
I do not believe Cat 9200 will be supporting Stackwise-virtual.
here is supported models. and config,
07-19-2019 10:58 AM
I do not believe Cat 9200 will be supporting Stackwise-virtual.
here is supported models. and config,
07-19-2019 01:39 PM
07-19-2019 01:52 PM
Suggest always verify on cisco site before buying any equiment, if not these device can not be used for the purpose the one purchased for.
if this is resolved can you mark as resolved. so usefull for other community members.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: