02-19-2012 05:58 PM - edited 03-07-2019 05:02 AM
Hi,
could anyone point me in the right direction. not too catOS savvy
I need to get the mac addresses and ip addresses off a few interfaces to which servers are connected to on a 6500 catOS switch. could point me to the commands i can issue to get these?
thanks!
02-23-2012 02:06 PM
to get the mac address try using "sh cam dynamic [interface #]
02-23-2012 02:39 PM
Hello Gerald,
the command listed by Mandlenkosi is correct, here is a further reference to it:
additionally, once you have the mac entry from the above command, you would need to find the ARP entries from the MSFC (if that is what you require as well).
HTH
Pronoy
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide