Hello,
I'm having trouble making a trunk between these two switches;
We have a cisco router with dmvpn and bgp that sends the DHCP scope to the network through the Huawei S5735 switch which is the core and from this switch a fiber goes out to the CBS250;
The Huawei has four Meraki antennas that distribute Vlan 1 and 18 and are working perfectly. Vlan 18 is a different network and I need it to reach and distribute the range to the Meraki antennas that are connected to the CBS250 switch and this is not happening, see below for the switch configurations:
Huawei port connected to the CBS250:
interface Gi25
port link-type trunk
port trunk allow-pass vlan 18
CBS250 port connected to Huawei:
interface Gi25
switchport mode trunk
switchport trunk allowed vlan 1,18
Port of the APs on the CBS250:
switchport mode general
switchport general allowed vlan add 18 tagged
switchport general allowed vlan add 1 untagged
On the APs port I've left only "switchport mode trunk" and even so people try to connect to the SSID of vlan 18 and don't get an IP, but on the Huawei it works.
