11-28-2007 05:50 AM - edited 03-05-2019 07:40 PM
Hello,
Is there a way of specifying the IP address that is seen by neighboring devices in the cdp table as the management address?
Thanks
11-28-2007 05:57 AM
It will always be the IP(if configured) of the interface out of which cdp packet is sent.You can not change this.
11-28-2007 06:06 AM
But what about a trunk. I have 3 VLANs at each end 10, 20, 30. Can I specify then? Native VLAN is 1.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide