Switching

Hi,6513 with Sup720 have WS-X6748-GE-TX and WS-F6700-CFC as daughercard/sub-module. So... 1.Does this by default comes with 256MB memory..?2.I want to upgrade memory to 512MB, what is the procedure 3.Can someone provide links with more information on...

We are getting ready to setup a new network which will involve 4 sites with all servers located in a central data center. We are currently looking at having about 50 computers at each site and we must make this work over 10mb Metro-Ethernet WAN links...

When interfaces on a Cisco 3750 are configured as part of a port-group using LACP (passive) what are the timers or delays associated with putting one of the ports into "suspend"? What is required to get a port out of "suspend"?Here is the scenario w...

Hi,i get a strange error, i get "input errors" on the span destination port. In this port is connected another switch, so is normal that's some input packets (stp, mcast, bcast, cdp ...) but why "input errors".here is the output of the "sh int "Gigab...

Hi all,one of my router interface is configured asinterface Serial1/0.1/3/6/2:0 description ## bandwidth 1024 ip address 10.10.10.1 255.255.255.252 rate-limit input 1024000 192000 384000 conform-action transmit exceed-action drop rate-limit output 10...

Hi,I am wondering if it is possible to use VRF selection based on source IP address on a 3750-24TS-E. The IOS version is c3750-ipservicesk9-mz.122-25.SEE4.bin. The switch allows me to put the commands in but I get the following:SW3(config)#vrf select...

Is there a way to track an IP instead of an interface when using HSRP Tracking?

Hi,in my Campus Lan, i've one core switch (4506) and several acess swicth (2950)On an access switch i create a monitor sesion to get trafic for a particular port. Works fine.On another switch (not in the same stack), i create another monitor session ...

Does anybody have an idea what is the MTTR for access layer switches and core switches?Thnaks

HelloI have a switch WS-C3560G-24TS (L2-L3 image)I have a telecom provider equipment connected to the int g0/1 of my switch and carries to my switch different vlans from remote sites (L2L).The DG IP @ is definedin my switch.I just want to know what i...

Hi,I have installed a 2851 with 4 x ADSL-HWIC's. Using CEF it is balancing the load across the links. All up it is working well, however there is only one issue at this stage.On a few web sites you can access things fine except then when you click on...

Hi,I'm trying to set up remote access to a Cat 3548XL using reverse telnet from a Xyplex 1604 Maxserver. I have configured the Xyplex and can access 2600 routers and also Cat 3550 switches without any problem. If I take the console from the 3550 and ...

Hello every one, We are looking to upgrade our network to achive the followings : 1. To have latest technologies in place. 2. To utilized latest features for data, voice & Video. 3. To have fully redundant setup etc. So, I need your valiable recommen...

Hi there , I have an issue , on creating a birectional acces-list .For example :1.1.1.1 255.255.255.0 2.2.2.2 255.255.255.0 251.1.1.1 255.255.255.0 25 2.2.2.2 255.255.255.0Is access-list correct , can it been done in this way rather then , 1....