Hi,
I 'd like to change redundancy mode from NFS to SSO. Someone could tell me if is there a specific procedure for that?
For example, must I shutdown backup supervisory before apply "mode sso" command or can i put mode sso without others actions?
I'd like to do that without stop network operation.
Regards,
Fabiano
Solved! Go to Solution.
Hi Fabiano,
If you change the mode from RPR to SSO, the stand-by sup will be rebooted.
for more info see
http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/31sga/configuration/guide/RPR.pdf
HTH
Hi Fabiano,
If you change the mode from RPR to SSO, the stand-by sup will be rebooted.
for more info see
http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/31sga/configuration/guide/RPR.pdf
HTH
Hi Sharifi,
Thanks for help. So I can put "mode sso" command without shutdown standby module.
Regards,
Fabiano
Correct, you don't need to shutdown anything.
To be sure, do this command during an outage window (just in case)
HTH
Reza