08-29-2011 09:11 AM - edited 03-07-2019 01:57 AM
Hi,
I 'd like to change redundancy mode from NFS to SSO. Someone could tell me if is there a specific procedure for that?
For example, must I shutdown backup supervisory before apply "mode sso" command or can i put mode sso without others actions?
I'd like to do that without stop network operation.
Regards,
Fabiano
Solved! Go to Solution.
08-29-2011 11:20 AM
Hi Fabiano,
If you change the mode from RPR to SSO, the stand-by sup will be rebooted.
for more info see
http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/31sga/configuration/guide/RPR.pdf
HTH
08-29-2011 11:20 AM
Hi Fabiano,
If you change the mode from RPR to SSO, the stand-by sup will be rebooted.
for more info see
http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/31sga/configuration/guide/RPR.pdf
HTH
08-29-2011 12:26 PM
Hi Sharifi,
Thanks for help. So I can put "mode sso" command without shutdown standby module.
Regards,
Fabiano
08-29-2011 12:31 PM
Correct, you don't need to shutdown anything.
To be sure, do this command during an outage window (just in case)
HTH
Reza
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide