cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
492
Views
0
Helpful
3
Replies

check if the traffic has been identified as class "EF"

ejlbarcelon
Beginner
Beginner

Hi I am not sure if this is the right place to ask this question about QoS.

I want to know if ther is a way to check if the specific traffic has been identified as class EF by auto QoS. how can I verify if the auto Qos has correctly tagged my traffic as "EF". If there is how can i do this on my routers and switches?

Thanks!

3 REPLIES 3

Farmerc01
Beginner
Beginner

ejlbarcelon

You could mirror one of the ports and capture the traffic.

the information should be visible in the capture.

The other option is to install a netflow capture box.

Most flavors of this (Solarwinds, crannog, Whatsup gold) can give good information when configured properly.

Hi,

how about for the cli commands? is there a debug or show command to show this?

ejlbarcelon wrote:

Hi,

how about for the cli commands? is there a debug or show command to show this?

I don't tend to use the CLI except to check the config is right, mappings etc.

i will have a look though.

try here:

http://docwiki.cisco.com/wiki/Cisco_IOS_Voice_Troubleshooting_and_Monitoring_Guide

and

http://www.voip-info.org/wiki/view/QoS

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: