Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have already enabled high-cipher on SSH, but for security compliance, I need evidence to show that the only version of SSH enabled on WLC is version 2 only. Is there a way to show this evidence?
Hi, I have a WLC that I need to restriction over the management GUI but do not want to block anything else.Is there a safe way to block other wireless client to the WLC GUI, while keeping a whitelist of those who can access?I am planning to enable "m...
Hi,I have 3 E1 bundled from same service provider and after a few months we had complaints regarding static noise heard over the the other line when we call someone from the office. This is random, at no particular time or day, but not always. When w...
Hi All, I need help in configuring basic auto attendant on my CME 10 using CUE 8.6.6.On older versions i just need to configure a dial-peer voice directing to my CME same as my voicemail config, but now it seems that it is not working. I have enabled...
Hi, I have SM-SRE-710-K9 and would like to add 10 more mailboxes, I have two quantities of FL-CUE-MBX-5. But I cannot find where to add license and does it require additional hardware (Hard drive) for this? se-10-115-82-3# show licenseIndex 0 Feature...
I have the same requirement, so will this bring down the ipsec vpn and auto re-establish, or do I have to do something on the both sides of the vpn to make it work again.
Please note that on one side aggressive mode has already been disabled.
I am trying to configure the sleeping client only now since we have an increase in clients using ipad on our guest network. Kindly correct me if I am wrong, if I enable Sleeping client and set it to 1440mins, and disable session timeout and client id...
