02-24-2020 06:05 AM
Hi,
After I was configuring cisco sg220-50P, I could not access the switch through browser by its management IP nor is ping reaching through cmd.
How to enable HTTP to access the GUI browser?
#sh line list
Line Type | AAA Type | List Name
-------------+-----------------+-----------------
console | login | default
| enable | default
telnet | login | default
| enable | default
ssh | login | default
| enable | default
http | login | default
https | login | default
02-24-2020 06:21 AM
Hi
page 575
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x471
Web Server Commands
ip http secure-server To enable the HTTPS service on the switch, use the ip http secure-server Global Configuration mode command. To disable the HTTPS service on the switch, use the no form of this command.Syntaxip http secure-serverno ip http secure-serverParametersN/ADefault ConfigurationThe HTTPS service is enabled by default. Command ModeGlobal Configuration modeExampleswitchxxxxxx(config)# ip http secure-serve
02-24-2020 06:24 AM
- Resolve the ping issue first and or set correct network-address and related parameters.
M.
02-24-2020 07:37 AM
Why is http and https shown as disabled?
02-24-2020 07:42 AM
02-24-2020 10:20 AM
Yes it was before as i could access the gui through google chrome.
But later after cli configuration to make it faster; i could not access the gui on Google or other browser.
On cli i cannot find how to correct or enable this
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide