12-28-2006 04:34 AM - edited 03-05-2019 01:30 PM
After installing a second 10 mb ethernet nm-1e module on a 2610 router, the e1/0 connects to my ISP cable modem - while e0/0 connects to my 2924xl switch for internal network.
Question: How should I configure IP addresses on these interfaces?
e1/0 = outside IP address? (given by ISP 65.33.x.x)
e0/0 = internal network IP address of 192.168.15.0/24? Is that it?
I will also need NAT and ACL configured on the router. I do not understand either very well.
12-28-2006 04:41 AM
config will look like this:
int e1/0
desc **** Connected to ISP****
ip address 65.33.x.x 255.255.255.252
no shut
ip nat outside
int e0/0
desc **** Connected to LAN Switch****
ip address 192.168.15.1 255.255.255.0
no shut
ip nat inside
access-list 1 permit 192.168.15.0 0.0.0.255
ip nat inside source-list 1 interface e1/0 overload
ip route 0.0.0.0 0.0.0.0 e1/0
you can use IP addressing scheme for LAN for any of the Class A,B, C range reserved for non-routable addressing scheme, it depends on the number of hosts in your network.
192.168.15.0/24 can accommodate 254 hosts in the network.
hope it helps ... rate if it does ...
12-28-2006 10:13 AM
Thanks for the NAT config. I will try it out.
1. I have a Linksys internet phone adapter that will connect on the lan switch. This adapter reqiures 4 UDP port ranges (Udp Port 69, 5060-5065, 10,000-20,000)to work. If ACL does not specifically deny any of these port ranges, do I need not worry about the ports on the router at all?
2. The ouside ISP IP address will change from time to time. Do I need to configure DHCP on the router to accept outside IP from ISP? If so, how do I configure DHCP.
12-28-2006 10:23 AM
A1. ACL used is just to configure NAT, it's not used to block any traffic. As, that ACL is not applied to router interface, hence not blocking any of the UDP ports mentioned.
A2. if ISP address change, you can config like this:
int e1/0
desc **** Connected to ISP****
ip address negotiated
no shut
ip nat outside
hope it helps .... rate if it does ...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide