cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
373
Views
0
Helpful
5
Replies

Cisco 2800 Pagent recovery

manojk6
Cisco Employee
Cisco Employee

Hi all,

i am getting bellow error after reloading the cisco2800 pagent router


rommon 1 > PC = 0xbfcd0908, Cause = 0x2000, Status Reg = 0x3040a803
PC = 0xbfcd0908, Cause = 0x2000, Status Reg = 0x3040a803
PC = 0xbfcd0d54, Cause = 0x2000, Status Reg = 0x3040a803

5 Replies 5

Leo Laohoo
VIP Community Legend VIP Community Legend
VIP Community Legend

Connect the console cable and reboot.  Post the entire boot-up process.  I want to see where it fails.

Getting this error

WARNING: Break key entered while upgrade ROMMON  was initializing.
Do you want to fall back to readonly ROMMON? (y/n) [n] PC = 0xbfcd0d54, Cause = 0x2000, Status Reg = 0x3040a803

Leo Laohoo
VIP Community Legend VIP Community Legend
VIP Community Legend

In ROMmon, enter the command "reset" and hit enter.  The router should reboot.

Tried but no luck

Leo Laohoo
VIP Community Legend VIP Community Legend
VIP Community Legend

Are there any WIC/NM installed?  If yes, remove them all and reboot again.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers