CISCO 2811 PASSWORD RESET

[alexa]

hello all-

i have a cisco 2811 i dont know the password that was set previously i was able to reset the router password, and gained access to it, but how do I reset the password on the service module?  Any assistance would be appreciated it.  

thanks

[Peter Paluch · Accepted solution]

Hi,

What kind of service module is that? These may have different password recovery procedures depending on their type.

At least for NM-WLC6, the following steps were required:

1. Configure the interface wlan-controller or interface service-module with an arbitrary valid IP address, say, 10.0.0.1/24, and no shutdown it.
2. Follow the steps in http://www.cisco.com/c/en/us/support/docs/wireless/2000-series-wireless-lan-controllers/71094-wlcm-pwr.html

Best regards,
Peter

[alexa]

i have a NME-16ES-1G-P Modudel

[Nadeem Ahmed]

Hello Alexa,

Are you being asked for a username/password after "service-module service-enging 0/0 session"? If so, check the line for the CUE module. In your router config, along with "line vty 0 4", etc you will have something similar to "line 194". Is this line set to require a login? If so, remove the login command.

also check below thread if this help

https://supportforums.cisco.com/document/93176/password-recovery-waas-installed-sre-module

Br,

Nadeem

[alexa]

i added this line and still nothing

transport output lat pad telnet rlogin lapb-ta mop udptn v120 ssh
line vty 0 4
 no login
 transport input all