08-27-2015 02:44 PM - last edited on 03-25-2019 04:35 PM by ciscomoderator
hello all-
i have a cisco 2811 i dont know the password that was set previously i was able to reset the router password, and gained access to it, but how do I reset the password on the service module? Any assistance would be appreciated it.
thanks
Solved! Go to Solution.
08-27-2015 04:36 PM
Hi,
What kind of service module is that? These may have different password recovery procedures depending on their type.
At least for NM-WLC6, the following steps were required:
Best regards,
Peter
08-27-2015 04:36 PM
Hi,
What kind of service module is that? These may have different password recovery procedures depending on their type.
At least for NM-WLC6, the following steps were required:
Best regards,
Peter
08-28-2015 05:51 AM
i have a NME-16ES-1G-P Modudel
08-27-2015 08:34 PM
Hello Alexa,
Are you being asked for a username/password after "service-module service-enging 0/0 session"? If so, check the line for the CUE module. In your router config, along with "line vty 0 4", etc you will have something similar to "line 194". Is this line set to require a login? If so, remove the login command.
also check below thread if this help
https://supportforums.cisco.com/document/93176/password-recovery-waas-installed-sre-module
Br,
Nadeem
08-28-2015 05:59 AM
i added this line and still nothing
transport output lat pad telnet rlogin lapb-ta mop udptn v120 ssh
line vty 0 4
no login
transport input all
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide