03-21-2011 11:05 PM - edited 03-06-2019 04:11 PM
I am working on WS-C2960-24LC-S and software Image C2960-LANLITEK9-M version 12.2(50)SE4.
I am trying enable TACACS management to that switch.
The IP TACACS source-interface vlan90 is executing but it is not visibile in running config.
where in IP TFTP source-interface vlan90 is executed and visible in running config.
Can anybody Advise.
Below is the command and sh run
Switch1(config)#ip tacacs source-interface vlan 90
Switch1(config)#do sh run | i source
no ip source-route
ip tftp source-interface Vlan90
logging source-interface Vlan90
snmp-server trap-source Vlan90
ntp source Vlan90
Switch1(config)#
03-22-2011 12:22 AM
Hi,
Maybe a stupid question but is aaa enabled?
Regards.
Alain.
03-22-2011 04:59 AM
Can you ping the tacacs aerver from the switch management address ? Tacacs server address and key defined?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide