CISCO 2960X Unable to boot-Syst LED blinking green
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-25-2018 02:26 AM - edited 03-08-2019 04:53 PM
Hi,
This error message is coming on Console Screen with
".................Image failed digital signature verification
Error loading "flash:/c2960x-universalk9-mz.152-2.E3/c2960x-universalk9-mz.152-2
.E3.bin"
Interrupt within 5 seconds to abort boot process.
Boot process failed...
The system is unable to boot automatically. The BOOT
environment variable needs to be set to a bootable
image."
I tried copy xmodem flash: Command but its very slow, will take 9 hours to complete, change Baud Rate to 115200, then Switch does not connect with Console, if change to 9600 then it connects again.
Please Help me in this matter.
- Labels:
-
Other Switching
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-25-2018 05:29 AM
In ROMmon, please post the complete output to the command "dir flash:".
