Here is what is in the flash;
85361 drwx 4096 .
2 drwx 4096 ..
85362 -rw- 2097152 nvram_config
85363 -rw- 2097152 nvram_config_bkup
85364 -rw- 15950464 cat3k_caa-guestshell.16.03.06.SPA.pkg
85365 -rw- 22302593 cat3k_caa-rpbase.16.03.06.SPA.pkg
85366 -rw- 265124472 cat3k_caa-rpcore.16.03.06.SPA.pkg
85367 -rw- 9095808 cat3k_caa-srdriver.16.03.06.SPA.pkg
85368 -rw- 211675764 cat3k_caa-wcm.16.03.06.SPA.pkg
85369 -rw- 13423228 cat3k_caa-webui.16.03.06.SPA.pkg
85370 -rw- 4737 packages.conf
85371 -rw- 1258 bootloader_evt_handle.log
85372 drwx 4096 core
23281 drwx 4096 .prst_sync
38801 drwx 4096 .rollback_timer
46562 drwx 4096 dc_profile_dir
46564 drwx 4096 gs_script
85373 -rw- 65301 memleak.tcl
85374 drwx 4096 .installer
1078792192 bytes available (571293696 bytes used)
switch: ?
? -- Present list of available commands
arp -- Show arp table or arp-resolve an address
boot -- Load and boot an executable image
cat -- Concatenate (type) file(s)
copy -- Copy a file
delete -- Delete file(s)
dir -- List files in directories
emergency-install -- Initiate Disaster Recovery
flash_init -- Initialize filesystem(s)
format -- Format a filesystem
fsck -- Check filesystem consistency
help -- Present list of available commands
mgmt_init -- initialize management port
mkdir -- Create dir(s)
more -- Concatenate (display) file(s)
ping -- Send ICMP ECHO_REQUEST packets to a network host
readrtc -- Read RTC
rename -- Rename a file
reset -- Reset the system
rmdir -- Delete empty dir(s)
set -- Set or display environment variables
set_bs -- Set attributes on a boot sector filesystem
set_param -- Set system parameters in flash
type -- Concatenate (type) file(s)
unset -- Unset one or more environment variables
version -- Display boot loader version
writertc -- Write RTC
As you can see you can't reset anything. No erase. I need to return this switch to the defaults as it will not boot. When you boot it goes into a loop and keeps rebooting.
I think that if I could bring the switch back to factory settings I may able to save it.
