07-01-2013 11:38 AM - edited 03-07-2019 02:10 PM
Hello All:
My topology is composed of Cisco 3750 LAN switches which are set up as stackables. I need to run some subcomponent show commands on both devices. There is a master 1 , and a slave 2. I am trying to find out if I can run simple show commands IE; Show inventory, show controllers, on the switch that is set up as the slave without making it the master first? I looked in the 3750 Cisco documentation but did not find anything that was apparent to me.
Thanks
Solved! Go to Solution.
07-01-2013 03:56 PM
Show inventory, show controllers, on the switch that is set up as the slave without making it the master first?
For logical reason, you can't run these commands if the slave isn't connected to the stack (and powered up).
You can run these commands on the slave switch and you'll get the output of the slave switch itself (if the slave switch isn't connected and powered up to the stack).
The simple rule apply:
1. If the switch is local, then you'll see the LOCAL output;
2. If the switch is part of the stack, then you'll see the entire stack output.
07-01-2013 03:56 PM
Show inventory, show controllers, on the switch that is set up as the slave without making it the master first?
For logical reason, you can't run these commands if the slave isn't connected to the stack (and powered up).
You can run these commands on the slave switch and you'll get the output of the slave switch itself (if the slave switch isn't connected and powered up to the stack).
The simple rule apply:
1. If the switch is local, then you'll see the LOCAL output;
2. If the switch is part of the stack, then you'll see the entire stack output.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide