cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Join Customer Connection to register!
372
Views
0
Helpful
4
Replies
Jelani_DTE_PRO
Beginner

Cisco 3850 start-up config (Stack)

Hello.

 

I am planning to create a stack, between an existing and new 3850. I would like to know, if I have to configure the new switch with (e.g. SSH, SNMP, switchport access, etc), or does SSO makes it possible for the new switch to use the existing running-config?

1 ACCEPTED SOLUTION

Accepted Solutions

Once you add the new switch to the stack, and the stack is operational, the master (assuming you want to keep the existing switch as master) will sync its config to the new switch. The new switch will be a member switch and after that you only login to the master to make any changes.

HTH

View solution in original post

4 REPLIES 4
Leo Laohoo
VIP Community Legend

The new switch will synchronize the configuration with the switch master.

Hi, Leo.

 

Will that take place via SSO or the software auto-upgrade enable command?

Once you add the new switch to the stack, and the stack is operational, the master (assuming you want to keep the existing switch as master) will sync its config to the new switch. The new switch will be a member switch and after that you only login to the master to make any changes.

HTH

View solution in original post

Got it. Thanks!