Hello everyone I hope someone can help me I just choose a 4507 RE used switch and I inserted a supervisor map Engine 6 THE WS-X45-SUP6 LE but the card reboots loop (continuous reboot ) still even after I give it the Boot command in Rommon mode for booting
Any help will be appreciated.
Thanks in advance.
**********************************************************
* *
* Welcome to Rom Monitor for WS-X45-SUP6L-E System. *
* Copyright (c) 2003-2009 by Cisco Systems, Inc. *
* All rights reserved. *
* *
**********************************************************
Checking the partition table and boot sector...
Checking FAT, Files and Directories...
Reclaiming unused space...
Updating FAT...
Rom Monitor Program Version 12.2(44r)SG5
CPU Rev: 2.1, Board Rev: 9, Board Type: 103, CPLD Nexu Rev: 9
Chassis: WS-C4507R-E
Front Panel Phy is Bcm5482s
Got Mac Address: 58:8d:09:49:9e:b2
MAC Address : 58-8d-09-49-9e-b2
IP Address : 192.168.10.227
Netmask : 255.255.255.0
Gateway : 192.168.10.228
TftpServer : Not set.
***** The system will autoboot in 5 seconds *****
Type control-C to prevent autobooting.
. . . . .
******** The system will autoboot now ********
config-register = 0x2101
Autobooting using the first file from bootflash.....
Rommon reg: 0x00004380
Reset2Reg: 0x00008EFF
#
Darkside controller 0x0B435613..0x0B4439C5 original size:0x00012092##
Fortooine controller 0x0B56E584..0x0B6AA214 original size:0x001A8529
#################
diagsk5 version 4.1.0
prod: WS-X45-SUP6L-E part: 73-13182-01 serial: JAE144100KL
Power-on-self-test for Module 4: WS-X45-SUP6L-E
Test Status: (. = Pass, F = Fail, U = Untested)
CPU Subsystem Tests ...
seeprom: Pass
Traffic: L3 Looopback ...
Test Results: Pass
Traffic: L2 Loopback ...
Test Results: Pass
Switching Subsystem Memory ...
Packet Memory Test Results: Pass
Module 4 Passed
Rommon reg: 0x00000380
##########################################################
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco IOS Software, Catalyst 4500 L3 Switch Software (cat4500e-IPBASE-M), Version 12.2(53)SG4, RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2011 by Cisco Systems, Inc.
Compiled Fri 25-Feb-11 15:14 by prod_rel_team
Image text-base: 0x10000000, data-base: 0x124334BC
VECTOR D00
Buffered messages:
Queued messages:
*Mar 2 03:24:31.171: %SYS-3-LOGGER_FLUSHING: System pausing to ensure console debugging output.
*Mar 1 00:00:01.463: %C4K_IOSSYS-3-BLANKSTARTUPCONFIG: Blank or invalid startup-config, booting up with defaults
*Mar 2 03:24:24.243: %C4K_REDUNDANCY-6-INIT: Initializing as ACTIVE supervisor
**********************************************************
* *
* Welcome to Rom Monitor for WS-X45-SUP6L-E System. *
* Copyright (c) 2003-2009 by Cisco Systems, Inc. *
* All rights reserved. *
* *
**********************************************************
Checking the partition table and boot sector...
Checking FAT, Files and Directories...
Reclaiming unused space...
Updating FAT...
Rom Monitor Program Version 12.2(44r)SG5
CPU Rev: 2.1, Board Rev: 9, Board Type: 103, CPLD Nexu Rev: 9
Chassis: WS-C4507R-E
Front Panel Phy is Bcm5482s
Got Mac Address: 58:8d:09:49:9e:b2
MAC Address : 58-8d-09-49-9e-b2
IP Address : 192.168.10.227
Netmask : 255.255.255.0
Gateway : 192.168.10.228
TftpServer : Not set.
***** The system will autoboot in 5 seconds *****
Type control-C to prevent autobooting.
. . . . .
******** The system will autoboot now ********
