cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

163
Views
0
Helpful
4
Replies
Beginner

Cisco 4510 not routing

I have a Cisco 4510 configured as attached.

I have a PC plugged into port gi2/1 with an ip address 10.100.1.201/24.  The PC is unable to reach the switch via ICMP and vice-versa.  None of the Vlans listed in the config show up when I run a show VLAN command.  What am I missing?

4 REPLIES 4
Beginner

Hi rx7heaven,

Hi rx7heaven,

do you have enabled the "ip routing"? In the configuration it seems not enabled. So please type in configuration: ip routing

Can you post the output of "show vlan"?

Is the router able to route on other networks or is it globally not working?

Participant

Hello.

Hello.

In addition to above.

Also show output of the command "sh interface status" when you connecting your PC to the network. In some cases you need to give command "no shutdown" at the "vlan #" (at the old IOS versions) and at the "inteface vlan #" because when you creating a vlan or vlan interface it has a shutdown status by default.

Also all virtual interfaces stays at the "down" status when all physical interfaces of this vlan in "down" status at can't give responce.

Best Regards.

Beginner

This is a new router that I

This is a new router that I am configuring in our lab.  So far the only devices plugged into it are a PC into port gi2/1 and a Cisco 2960 into port te1/1.  The other end is plugged into port te1/0/2 on the 2960.  I have entered the ip routing command a number of times, with no effect.  When I reload the switch the ip routing line disappears from the running config.

Highlighted
Hall of Fame Guru

If the vlans are not in the

If the vlans are not in the database then the SVIs won't come up.

Did you create them ?

What does "sh vtp status" display ?

You do not need to use the "ip routing" command as it is on by default.

Jon

CreatePlease to create content
Content for Community-Ad