Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Get 20% off switches when you combine Cisco solutions

 
Labels

Forum Posts

Hi have a brand new 3750x 48P to connect in stack to a old 3750-48P. my problem is the sw version, which software version should I use to enable the stack? Switch   Ports  Model              SW Version              SW Image ------   -----  -----    ...

Hello, I would like to run a debug on a switch that is having PoE issues.   My question is:  when i run the debug, how come I don't see anything?  I don't see any debugs populating my screen.  Where do they all go?  I know for sure it works because ...

afsharki2 by Level 1
  • 5372 Views
  • 8 replies
  • 0 Helpful votes

Cisco has RMA'd one of our VSS members because of a hardware problem.  The broken VSS member is still up and the pair is communicating, but as the passive member.  My question is, what is the correct procedure to replace the passive member of a VSS p...

Hi experts, I have a setup that I have a WAN interface connected to the outside, and a few sub-interfaces (on a different physical port) on the LAN side to some VLANs. I also NAT on traffic between LAN and WAN. In order to record the flow with the or...

Hi guys, I'm always confused/concerned in term of performance when traffic ingress/egress the same physical interface (hairpining). Is there really a performance issue for the hardware buffer interface? What about if we use sub.interfaces. Traffic ...

dlongpre by Level 1
  • 575 Views
  • 3 replies
  • 0 Helpful votes

Hello,  I want to know the difference between forwarding rate bandwidth, forwarding performance and forwarding rate for example WS-C3650-24TS-S Performance Switching capacity : 88 Gbps Forwarding performance : 65.47 Mpps

Resolved! qos input-queue

hello,had a question regarding the configuration of the ingree-queue on a 3560. Here is the configuration from my switchmls qos srr-queue input threshold 1 8 16mls qos srr-queue input threshold 2 34 66mls qos srr-queue input dscp-map queue 1 threshol...

I am trying to evaluate whether to use PTP in unicast mode or in mixed unicast/multicast mode. the advantage of using the multicast mode is to reduce the load on the master for sync and announce messages. does anyone has experience using the mixed mo...

yairn1975 by Level 1
  • 333 Views
  • 0 replies
  • 0 Helpful votes

I have a 1921, trying to setup port g0/1 as a trunk port to access our two vlans.  Devices will have been tagged with clan id of 10.  I assume that I am fundamentally missing something, because I can not set switchport mode trunk on g0/1. Current co...

Review Cisco Networking for a $25 gift card