Any help would be appreciated on the scenario below. I'm more familiar with asdm gui than command line.
I have 5 Static IP Addresses from my ISP
I have the following interfaces. Outside (vlan 2) / Inside (vlan 1) / Guest (vlan 3)
For my Vlan3 guest network I have set it up so that DNS must be routed through opendns.org's DNS servers ( for web filtering, etc ) However, its using the static ip that I have plugged into the ASA.
What I would like to accomplish is to put my inside interface (vlan1) on another static ip for outside access if thats possible, so that I can route those clients through opendns.org however however giving them more web privlieges than what the guest network is getting.
Currently when changing the Authentication Template under the Onboarding section, there is no choice but to remove SGTs, VNs and IP Pools which clearly disrupt existing services.
Hitless Authentication was introduced in...
Hi, I want to redistribute OMP routes to BGP, i have the doubt if all of the OMP prefixes located in the local vEdge will be redistributed to BGP or just the connected+static networks located in the vEdge. Also how can i restrict some OMP prefix...
Let's say we have two routers configured as RP candidates for auto-RP: R1 - "advertising" its loopback0 interface IP address 188.8.131.52 as the RP for these groups:184.108.40.206/32220.127.116.11/3218.104.22.168/2422.214.171.124/16 R2 - "advertising" its loopback0 int...
hi,i just performed an IOS upgrade and got a report that admin can't create L2 VLANs.i noticed the 'vtp primary force' and 'vtp primary mst' was applied to one of the core switch and perhaps got lost after the upgrade.how to keep the VTP primary persisten...