03-17-2017 07:37 PM - edited 03-08-2019 09:48 AM
I have worked on lower end Cisco 1900 routers and it seems the syntax needed on the ASR1001-X is different.
Can someone provide some guidance on how to build the same network 16.0.0.1/24 on Ge0/0/0 and Ge0/0/1 under a common VLAN, so two firewalls can plug into router and be redundant of each other.
Thanks in advance,
03-18-2017 04:49 PM
ASR's run IOS-XE, not IOS, so that is why they are a little different.
You'll need to use a BDI:
For example, to bridge VLAN100 on two different ports you would use something like:
interface Gig0/0/0 service instance 1 ethernet encapsulation dot1q 100 bridge-domain 1 interface Gig0/0/1 service instance 1 ethernet encapsulation dot1q 100 bridge-domain 1 interface BDI1 ip address x.x.x.x
07-25-2020 07:15 AM
Does not work...
07-25-2020 08:38 AM
Sorry that it did not work for you. The suggested solution looks appropriate to me. Can you tell us the specifics of what model router and what version of code you are running? And can you show us the specifics of what you configured and any error messages generated by that config change?
07-25-2020 10:58 AM
Hello,
the only thing that I can think of that could be missing is the line in bold:
interface Gig0/0/0
service instance 1 ethernet
encapsulation dot1q 100
--> rewrite ingress tag pop 1 symmetric
bridge-domain 1
!
interface Gig0/0/1
service instance 1 ethernet
encapsulation dot1q 100
--> rewrite ingress tag pop 1 symmetric
bridge-domain 1
!
interface BDI1
ip address x.x.x.x
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: