Cisco Broadcast & Multicast Storm Control

[balbeer.singh84]

Hi,

I am going to configure the storm control in the switches & I am using the below commands :

//

interface <interface-list>

storm-control broadcast level 30.00

storm-control multicast level pps 5 3

//

I am applying this for all the access ports of the switches which are connecting to end users.

Please suggest whether I should apply this to uplink (trunk) ports of teh switches as well or not? If yes then what should be the limit on uplink (trunk) ports?

Please suggest.

-Balbeer

[singhaam007]

hello Balbeer,

you can use storm control config to control broadcast traffic.

Check this link for detail config

http://www.cisco.com/en/US/docs/switches/lan/catalyst2950/software/release/12.1_22ea/SCG/swtrafc.html#wp1063295

hope fully this will help.

thanks