Cisco C9200L and Zebra DZ421 Printer

[TomasKyjovsky]

Hi Gents,

I have brand new Cisco C9200L-24P-4X-E and Zebra ZD421 Printer. 

When I try to connect printer on specific port (or any other else btw.). With static IP or DHCP, obtain no IP, no MAC address.

Checked with:

sh Mac address-table interface 1/0/15

Port speed AUTO, switchport mode access.. 

Any idea?!

[Leo Laohoo]

What firmware is the switch on?

Post the complete output to the command "sh interface G1/0/15".

[TomasKyjovsky]

HI @Leo Laohoo 

See below:

[Leo Laohoo]

That is not what I am asking for.  

Please read and understand my response.

[TomasKyjovsky]

Sorry Sir:

[Leo Laohoo]

And what happens if a PC is connected to the ethernet port of the printer, does the link light flash?

[TomasKyjovsky]

I tried to connect Aruba Switch... also working smooth.. 

[Leo Laohoo]

What firmware is the switch on, 17.9.4?

[TomasKyjovsky]

17.3.5 ...Upgrade needed, you think?

[Leo Laohoo]

No, not yet. 

@Philip D'Ath is having similar problems (Cisco 9300L stack failing to learn MAC addresses dynamically).

[TomasKyjovsky]

I saw this post, but help me not in this time

[Leo Laohoo]

Is this switch a member of a stack or is this a stand-alone switch?

[TomasKyjovsky]

Stand-Alone ...

[Leo Laohoo]

If the Zebra printer is connected to port 15, is there anything active in ports 14 and/or 16?

[TomasKyjovsky]

My Computer is connected in port Gi1/0/13... in same VLAN. I tried put switch into Rack in Production, all ports and devices works fine although Zebra Printer. I tried to set Static IP in specific VLAN, Static IP in VLAN1, nothings working. Blinking well, cable in good shape.