Cisco Catalyst WS-C2960L-24TS-LL - No IP and WebUI

[Hiddai]

Cisco Hi,

Unfortunately, I tried to reset my device through the configuration CLI tab in IOS-WebUI and I ruined it.

Now, I see no IP (no 10.0.0.1 or the IP the device got from DHCP).

Also, I can't browse to it's IOS WebUI.

Please, help me to recover the device.

Guide me to the simplest way to recover it (anyway, I'm junior).

I have a RJ45-USB console cable.

Thanks!

[balaji.bandi]

it should be done in configuration mode

post complete command entered in the console logs.

[Hiddai]

Thanks bandi.

I'll stop here, since after reload the switch and connecting to 10.0.0.1 - the WebUI is loaded properly.

[paul driver]

Hello

The switch does have an ip address allocated to it, but it doesn’t have a default-gateway so you wont be to remote access this switch unless you are on the same subnet as the switch.
You could do one of two things:

1) Make the switch a dhcp client
conf t
interface vlan 1
ip address dhcp

or

2) assign the switch a default-gateway <  this will be the ip address of the device perfroming the routing vlan vlan 1
conf t
ip default-gateway 10.0.0.X