Cisco CBS220-8T time setting issue
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-20-2023 11:24 PM
Hello,
I have a problem with the Cisco CBS220-8T that I am using.
In the webpage at administration/time settings I select manual settings to set the date an time. I import it from my pc, it reads it ok but when I press apply it goes back to the value that was shown at the beggining (for ex 2022-Nov-30). If I press apply again it shows 2021-nov-30. If i press apply again it shows 2020-nov-30. You got the ideea.
The firmware version is 2.0.1.5 on some of them and 2.0.1.9 on others.
I cannot connect them to the internet.
Can anyone help me.
Thank you.
- Labels:
-
LAN Switching
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-05-2023 12:40 AM
This response was generated by a Cisco-powered AI bot and vetted by a Cisco Support Engineer prior to publication.
This is part of a monitored experiment to see if the bot can help answer questions alongside community members. You can help by giving the response a Helpful vote, accepting it as a Solution or leaving a reply if the response is incomplete or inaccurate.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-05-2023 03:39 AM
Hello,
On one of them I allready upgrade the firmware to the latest version that was available arround the time I posted. The problem persist. I discovered that 2 other sw CBS220-24T prezent the same problem.
Other sw CBS250, CBS350 doses not have any problems.
So... Other ideas? Maybe a glitch in the intenal software.
Thank you.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-30-2024 02:12 AM
Hello,
I solved the problem by adding a time server from my network to Administration/Time Settings/SNTP Setting
