A colleague of mine has installed a set of 3 Cisco IE-3000-8TC switches which look like they have had a minimal amount of configuration applied to them, and I have now been asked to integrate them into a CNA community.
I can;
- ping them and get replies
- connect to them through telnet
- connect to them with a web browser
I can create a community and the 3 switches are detected as shown in the attached file, CreateCommunity.png
However, when I try to connect to the newly created community CNA returns the error –1, as shown in the attached file, CommunityError.png
It then hangs at 83% Processing discovered devices…
Has anyone out there had experience of integrating these switches into CNA?
What do I need to do to them?