11-02-2015 11:04 PM - edited 03-08-2019 02:32 AM
Hello Everyone!
I have problem to my cisco switch. Please see below image to the error:
Only symbol appear while booting the cisco switch.
The led light of the syst of cisco switch are the one blinking....
11-02-2015 11:06 PM
Try this:-
press and hold mode button.
11-02-2015 11:18 PM
Hi InayathUlla Sharieff
I already try this but still error occured.
11-03-2015 06:33 AM
Are you sure your terminal emulator is set to 9600 - n - 8-1 ?
11-03-2015 05:46 PM
yes terminal emulator set to 9600-n-8-1 but same probel occur. i try also other settings of bps but still the same.
11-03-2015 03:30 PM
This appears to be a BAUD rate issue. check to make sure you're using the correct BAUD rate, default is 9600, but people like to get crazy for xmodem transfers and bump it up to a higher value.
11-03-2015 11:56 PM
i already changed to other baud rate but no match find. Do you have any solution regarding this error?
11-04-2015 08:25 AM
are you able to get into the password recovery stage? holding the mode button for 15-20 seconds upon power-on?
should prompt you for 'switch:'
11-04-2015 04:41 PM
Nope, when i try to hold mode button for 15-20 seconds upon power on the immediate prompt are the symbols not the "switch:"
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide