06-04-2023 12:23 AM
Hi All,
i have a cisco switch 2960x, which i want to factory reset. i remain pressed mode button for 30-60 Second while powering on but switch not goes to ROMMON Mode. However it shows password recovery mechanism is enable. but it every time load previous configuration.
Kindly advise and support.
Thanks
06-04-2023 12:39 AM
- Attach a console to the device , and see what happens when you try to factory reset , if after 3 seconds you get a prompt (e.g.) , you can also try : flash_init
M.
06-04-2023 05:05 AM
noted, will do.
06-04-2023 04:17 AM
Hello
atrach a console cable before you power up switch-
Then power on switch whilst you de-press the mode button -
wait for the sys light to flash and let go-
At console prompt - flash_init
delete flash:config.text
delete flash:vlan.dat
Boot
06-04-2023 05:09 AM
hi Paul,
i tried this many times but never observe behavior of SYS Led, will observe and revert back to you.
06-04-2023 06:40 AM
Hi, I'm not sure if this will work but can you try command 'write erase' then 'reload'?
06-04-2023 07:05 AM
Cli command will work after entering the switch, but the questions is this, I am not able to enter into the switch.
06-04-2023 01:44 PM
The Cisco Switch 2960x sometimes does not reset to its default settings by simply pressing the mode button. This can be frustrating for users who want to restore the switch to its factory configuration. In such cases, it is recommended to try alternative methods, such as using the console cable and accessing the switch's command-line interface (CLI), or utilizing the password recovery process provided by Cisco. These approaches can help troubleshoot and resolve the issue, allowing users to successfully reset the Cisco Switch 2960x to its default state.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide