Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Switch boot in bundle mode. Please advice to boot in classic ios mode. it showing only
.pkg
files in flash.
switch: dir flash:Directory of flash:/46465 drwx 4096 .2 drwx 4096 ..46466 -rw- 83293932 cat3k_caa-base.SPA.03.06.06E.pkg46467 -rw- 3982012 ca...
Hi All,when i tried configure Cisco ISR 4331 Router it hanged 2 twice and i restart it, after restart, Router Booting with image ISR Software (X86_64_LINUX_IOSD-UCMK9-M), Version 16.9.2, RELEASE SOFTWARE (fc1). Instead of ISR Software (X86_64_LINUX_I...
Hi All,i have a cisco switch 2960x, which i want to factory reset. i remain pressed mode button for 30-60 Second while powering on but switch not goes to ROMMON Mode. However it shows password recovery mechanism is enable. but it every time load prev...
Hi Leo,
after running emergency install command. it produce some unexpected errors. and return to previous stage. below is the outcome.
switch: emergency-install sbflash0:cat3k_caa-universalk9.16.12.08.SPA.binnknown cmd: emergency-installusbflash0:ca...
so what method i used to do ios installation. because if i go for
tftp/xmodem
installation lan port not blinking in switch when lan cable connected to laptop. laptop lan is ok tested.
usb not supported. please tell me how can i format pendrive from switch in rommon mode.
switch: format usbflash0:
Format of filesystem
usbflash0:
not supported!
