Cisco Trustsec and VSS on pair of 6500 sup2T and Intefaces SGT dubt

[ifabrizio]

Dear All,

I am planning to configure Cisco trustsec on two 6500 with Sup2t, conncted eachothers with two VSS links.

There are some additional configs that I need to setup?

The links that belongs to VSS need to be configured with:

Cts manual

Policy static sgt 600  <--switches Interfaces dedicated SGT

Trusted

Propagate sgt

Or there is no need to do it?

Last question is about the SGT value to assign to the Interfaces links, it should be different from the Network Devices SGT, it is true? If yes I should create a policy to permit truffic between the Interface SGTs?

Bye,

JF.

[balaji.bandi]

Personally i would not add any config on that Links.

check below :

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst6500/ios/15-1SY/config_guide/sup2T/15_1_sy_swcg_2T/virtual_switching_systems.html#pgfId-1341144