Class-Map Cisco 3850

[pjdouglas42]

Hi

I'm setting up a policy map on a Cisco 3850 switch. But having trouble matching an interface.

On the 3750 model you could match traffic on an input interface:

 Class-map match-all Example

 match input-interface G1/0/10 - G1/0/11

I wish to setup similar on a 3850, only Cisco appear to have remove this feature as the input-interface command is not available.

Does anyone know the syntax or a way to match an interface using class-map for use with a policy map and policing traffic ?

Thanks

[Georg Pauwen]

Hello,

I think the closest you can get is 'match vlan', assuming that all ports are part of the same Vlan.

[pjdouglas42]

Thanks Georg,

The interfaces in question are trunks; so I would need to match against several vlans.

Is there any reason why cisco removed this command ? There does not seem any rationale behind it, it was a useful command to have.....

Thanks

Paul