Hi, is there any shortcute to go from 'config-if' back to 'config'.
All I can seem to manage is "ex".
When I use CTRL-C, it takes me right out of config mode, but all I want to do is go back to general config mode ?
Is there anything better ?
In classic ios there is not. In nx-os you can use push and pop.Sent from Cisco Technical Support Android App
This is IOS right ?Exit = go up oneEnd = go out to priv exec modeDo you know that many of the config commands can be entered in config-if to switch directly without needing to go back to config?Sent from Cisco Technical Support iPad App
I mean, you can configure for example an IP route while being inside an interface, the gotcha is that you cannot use any help or the tab completion.
R1(config)#interface loopback 1
R1(config-if)#ip add 18.104.22.168
*Mar 1 00:00:15.951: %LINEPROTO-5-UPDOWN: Line protocol on Interface Loopback1, changed state to up
R1(config-if)#ip add 22.214.171.124 255.255.255.0
R1(config-if)#ip route 0.0.0.0 0.0.0.0 loo 1
As you can see I did not need to go to config mode but again you will need to know the command from the top of your head
Is that or using exit ( No such a command as the top from the Junos box; unless runing the nx-os as Colling mentioned)
Rate all of the helpful posts!!! Regards, Jcarvaja Follow me on http://laguiadelnetworking.com
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: