04-01-2016 12:34 PM - edited 03-08-2019 05:11 AM
I have been trying to configure a 3850 switch from the 3750x configurations we currently are using. The one part of the configuration I haven't been able to move over is the Macro we have to auto configure the 3750x ports when one of our 3602 LWAPs are plugged in. On the 3750 we have a macro that we call CAPWAP and it triggers when is see's our AP plugged into a port and configures it to be a trunk (see macro below). But on the 3850 it doesn't seem to work. I tried changing the name to CISCO_WIRELESS_LIGHTWEIGHT_AP_EVENT and it does make some changes but doesn't seem to be executing the macro correctly.
macro auto execute CAPWAP {
if [[ $LINKUP == YES ]]
then conf t
interface $INTERFACE
no sw acc vl 10
no switchport voice vlan 200
no auto qos voip cisco-phone
no authentication event fail action next-method
no authentication event server dead action authorize vlan 10
no authentication event server alive action reinitialize
no authentication host-mode multi-auth
no authentication open
no authentication order mab dot1x
no authentication priority mab dot1x
no authentication port-control auto
no authentication periodic
no authentication timer reauthenticate server
no authentication violation restrict
no mab
no dot1x pae
no dot1x timeout tx-period
switchport trunk encap dot1q
switchport mode trunk
switchport trunk native vlan 98
switchport trunk allowed vlan 98,104,120,128
description *** AP Port ***
macro description $TRIGGER
exit
else conf t
interface $INTERFACE
switchport mode access
sw ho
sw acc vl 10
switchport voice vlan 200
auto qos voip cisco-phone
authentication event fail action next-method
authentication event server dead action authorize vlan 10
authentication event server alive action reinitialize
authentication host-mode multi-auth
authentication open
authentication order mab dot1x
authentication priority mab dot1x
authentication port-control auto
authentication periodic
authentication timer reauthenticate server
authentication violation restrict
mab
dot1x pae authenticator
dot1x timeout tx-period 10
no switchport trunk native vlan 98
no switchport trunk encap dot1q
no switchport trunk allowed vlan 98,104,120,128
no description *** AP Port ***
no macro description $TRIGGER
exit
fi
}
Thanks for any help.
04-01-2016 05:23 PM
Kindly move this thread to the EEM section.
08-26-2016 02:35 AM
HI There,
Do you know what happened to traditional user macros in IOS-XE?
Kind regards,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide