03-10-2014 10:21 AM - edited 03-07-2019 06:37 PM
I am puzzled. I have followed all of the documentation for setting up a port on our 3750 with span but when I plug the PC with wireshark nothing happens.
So far this has been my configuratuion:
monitor session 1 source interface Gi1/0/1 - 22 rx
monitor session 1 destination interface Gi1/0/23
and I also set up gig1/0/23 as an access port.
When I plug in the ethernet cable from the PC I still get a down/down on int gig 1/0/23.
Am I doing something wrong?
Solved! Go to Solution.
03-10-2014 11:04 AM
Hello,
Down,Down.
Hmm so you sure you have the port in no shut state? That is not on error-disabled state? that the cable is good?, etc.
Regards,
Jcarvaja
03-10-2014 11:04 AM
Hello,
Down,Down.
Hmm so you sure you have the port in no shut state? That is not on error-disabled state? that the cable is good?, etc.
Regards,
Jcarvaja
03-15-2014 10:18 PM
Do u have any question right now??
Otherwise mark the question as answered so we can call it closed.
Regards
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide