02-25-2012 06:43 AM - edited 03-07-2019 05:10 AM
I am trying to copy my IOS to my pc using Solarwinds.
Solarwinds is Started.
I am able to ping from my pc to the fa0/1 port on my switch.
These are in the same subnet.
-------------------------------------------------------------------------------------
Pinging 192.168.1.100 with 32 bytes of data:
Reply from 192.168.1.100: bytes=32 time<1ms TTL=255
Reply from 192.168.1.100: bytes=32 time<1ms TTL=255
Reply from 192.168.1.100: bytes=32 time<1ms TTL=255
Reply from 192.168.1.100: bytes=32 time=2ms TTL=255
Ping statistics for 192.168.1.100:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = 0ms, Maximum = 2ms, Average = 0ms
---------------------------------------------------------------------------------------
Switch(config-if)#do ping 192.168.1.50
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.1.50, timeout is 2 seconds:
!!!!!
--------------------------------------------------------------------------------------
Here is the error...
Switch#copy flash tftp
Source filename []? c3550-ipbasek9-mz.122-25.SEB4.bin
Address or name of remote host []? 192.168.1.50
Destination filename [c3550-ipbasek9-mz.122-25.SEB4.bin]?
.....
%Error opening tftp://192.168.1.50/c3550-ipbasek9-mz.122-25.SEB4.bin (Timed out)
-----------------------------------------------------------------------------------------
appreciate any help.
Solved! Go to Solution.
02-25-2012 06:49 AM
Hi,
Please check if have firewall enabled on the PC. If it is enabled disable it or open port 69 ofr tftp.
Best regards,
Alex
*Please rate helpful posts.
02-25-2012 06:49 AM
Hi,
Please check if have firewall enabled on the PC. If it is enabled disable it or open port 69 ofr tftp.
Best regards,
Alex
*Please rate helpful posts.
02-25-2012 07:00 AM
God bless. been working on this for days.
03-07-2018 07:09 PM
hello,
The same error here. but I am able to copy a different file like a sample text file (text.txt) from tftp to flash
Please help..
11-27-2013 12:55 PM
I too had this problem.
When I was trying to copy from tftp to flash , the transfer would start and then would terminate in the middle and would give the error "timed out"
I could even see in the tftp server logs that the transfer was happening and suddenly stopped. I was using tftpd32
Later I found out the reason to be duplex mismatch
I went to interface config and then corrected the duplex setting and the transfer happened perfectly.
Hope this response helps those for whom transfer stops due to this error.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide