Hello, colleagues. Ive got a 494810ge switch, and this parameters are important for me:
sh int gi 1/4 counters detail
Port InBytes InUcastPkts InMcastPkts InBcastPkts
Gi1/4 252819467437788 173264735013 10827 760
Port OutBytes OutUcastPkts OutMcastPkts OutBcastPkts
Gi1/4 36657317030233 280590958051 5248439 5443194
Port InPkts 64 OutPkts 64 InPkts 65-127 OutPkts 65-127
Gi1/4 558420918 205564441592 2627477631 60865368994
Port InPkts 128-255 OutPkts 128-255 InPkts 256-511 OutPkts 256-511
Gi1/4 67277292 330580991 246243903 1412296297
Port InPkts 512-1023 OutPkts 512-1023
Gi1/4 933864754 597344078
Port InPkts 1024-1518 OutPkts 1024-1518 InPkts 1519-1548 OutPkts 1519-1548
Gi1/4 169123398738 11831617696 0 0
Port InPkts 1549-9216 OutPkts 1549-9216
Gi1/4 0 0
Port Tx-Bytes-Queue-1 Tx-Bytes-Queue-2 Tx-Bytes-Queue-3 Tx-Bytes-Queue-4
Gi1/4 36657016911015 64 7955410 292200036
Port Tx-Drops-Queue-1 Tx-Drops-Queue-2 Tx-Drops-Queue-3 Tx-Drops-Queue-4
Gi1/4 72633446 0 0 0
Port Dbl-Drops-Queue-1 Dbl-Drops-Queue-2 Dbl-Drops-Queue-3 Dbl-Drops-Queue-4
Gi1/4 555178 0 0 0
Port Rx-No-Pkt-Buff RxPauseFrames TxPauseFrames PauseFramesDrop
Gi1/4 0 291936632 0 0
Port UnsupOpcodePause
Gi1/4 0
Some parameters i can get by snmp (InBytes,InUcastPkts,InMcastPkts, and so on from out), but how can i take other parameters? I would like to do it by snmp but i did not find proper oids. Now I making a sheme like this: eem every 90 seconds takes this info and writes it down to file into nvram and then send it by scp to server, where file is processed by monitoring system script. It is not very good, cause cisco system cpu sometimes spikes of this and i dont know a resourse of nvram, how much times can i write to it?
