cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
578
Views
0
Helpful
2
Replies
Highlighted

counters detail by snmp

Hello, colleagues. Ive got a 494810ge switch, and this parameters are important for me:

sh int gi 1/4 counters detail

Port                InBytes       InUcastPkts      InMcastPkts       InBcastPkts

Gi1/4       252819467437788      173264735013            10827               760

Port               OutBytes      OutUcastPkts     OutMcastPkts      OutBcastPkts

Gi1/4        36657317030233      280590958051          5248439           5443194

Port              InPkts 64        OutPkts 64    InPkts 65-127    OutPkts 65-127

Gi1/4             558420918      205564441592       2627477631       60865368994

Port         InPkts 128-255   OutPkts 128-255   InPkts 256-511   OutPkts 256-511

Gi1/4              67277292         330580991        246243903        1412296297

Port        InPkts 512-1023  OutPkts 512-1023

Gi1/4             933864754         597344078

Port       InPkts 1024-1518 OutPkts 1024-1518 InPkts 1519-1548 OutPkts 1519-1548

Gi1/4          169123398738       11831617696                0                 0

Port       InPkts 1549-9216 OutPkts 1549-9216

Gi1/4                     0                 0

Port       Tx-Bytes-Queue-1  Tx-Bytes-Queue-2 Tx-Bytes-Queue-3  Tx-Bytes-Queue-4

Gi1/4        36657016911015                64          7955410         292200036

Port       Tx-Drops-Queue-1  Tx-Drops-Queue-2 Tx-Drops-Queue-3  Tx-Drops-Queue-4

Gi1/4              72633446                 0                0                 0

Port       Dbl-Drops-Queue-1 Dbl-Drops-Queue-2 Dbl-Drops-Queue-3 Dbl-Drops-Queue-4

Gi1/4                 555178                 0                 0                 0

Port         Rx-No-Pkt-Buff     RxPauseFrames    TxPauseFrames   PauseFramesDrop

Gi1/4                     0         291936632                0                 0

Port       UnsupOpcodePause

Gi1/4                     0


Some parameters i can get by snmp (InBytes,InUcastPkts,InMcastPkts, and so on from out), but how can i take other parameters? I would like to do it by snmp but i did not find proper oids. Now I making a sheme like this: eem every 90 seconds takes this info and writes it down to file into nvram and then send it by scp to server, where file is processed by monitoring system script. It is not very good, cause cisco system cpu sometimes spikes of this and i dont know a resourse of nvram, how much times can i write to it?

2 REPLIES 2
Highlighted

Up!

Highlighted

Anyone?

Content for Community-Ad