CUCM, command line interface and IOS

[John Cheetley]

Hi Guys and Girls,

What would be the command to show all hardware inventory in the command line for CUCM 6.0?

Thanks in advance again.

[matthay · Accepted solution]

Hi John,

The command to show hardware inventory is "show hardware". Here is a good source on maintaining CUCM Hardware: http://docwiki.cisco.com/wiki/Monitoring_and_Maintaining_CUCM_Appliance_Hardware.

Thanks,

Matt

[John Cheetley]

Hi Matthay,

Thanks Matthay for your help earlier.

I have run that command but unfortunately doesn't show the hardware on the router.

Let me explain if I can please

Just added NM-2V to 2691 router and powered up

This has a VIC-2-DID part in it

The LED on NM-2V doesn't luminate to indicate/show that the device has passed its self-test

And what's more. Trying to add this as a gateway in CUCM. The program shows that listing of NM-2V but not progress. 

Thanks again

[John Cheetley]

Further to this. I have re-added the part in CUCM. However. Only shows 3 options

VIC-2FXS

VIC-2FXO

VIC-2BRI

Nothing for VIC2DID

I was under the impression via this link http://www.cisco.com/c/en/us/support/docs/routers/2600-series-multiservice-platforms/5111-voice-comp-matrix.html#platform 

That 2691 router with NM-2V support above 4 plus more..

Unless there is another site for CUCM supported hardware

Thanks again