02-09-2022 06:00 PM
Hello, I'm student and I have couple of issue. Doing the ping from PC4 to PC2 says destination host unreachable. Also I did #ip route and #clock rate for every network and interface and it still says "request timed out". If you can answer too, is it okay to connected Router0 to PC1 like this. Thank You so much! Sorry for my bad English.
Here is my project: https://ufile.io/8phkhvix
Solved! Go to Solution.
02-10-2022 12:00 AM
Hello,
there is no router between PC2 and PC4. From which IP address to which IP address are you trying to ping ?
Also, what instructions are you following ? You are using static routes, which is tedious at least.
02-13-2022 02:49 AM
Hello,
attached the revised file with end to end connectivity (saved in Packet Tracer version 8.1). There were a few issues:
--> missing or wrong static routes
--> missing Vlans on Vlan 5 and Vlan 10 switches
--> missing subinterfaces for Vlan 5 and Vlan 10 on Router 1
02-09-2022 06:23 PM
Hi, do you start to create VLAN on the router1 , search on youtube channel "vlan cisco", and for the question to connect pc with router not is commun to do that, but is incorrect to connect switch - pc - router
02-09-2022 06:30 PM
02-09-2022 07:49 PM
ah ok, but maybe is a mistake, the correct order is router - switch - pc, or maybe you have to put in correctly orden and is part of evaluation of practice.
02-09-2022 07:54 PM
Hi,
destination host unreachable message occurs when network not available in routing table. check your routing tables.
02-10-2022 12:00 AM
Hello,
there is no router between PC2 and PC4. From which IP address to which IP address are you trying to ping ?
Also, what instructions are you following ? You are using static routes, which is tedious at least.
02-13-2022 02:49 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide