cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

590
Views
0
Helpful
7
Replies
Beginner

disconnect device on switch

Hello 

I have 4 devices about the light system and these device connected cisco 2960 switch

I can access these devices (ping ), after some time  I cannot access 

I see "switch port up and connect on 2960 switch"

if I use dummy switch these devices never disconnect and every time access 

I tried no cdp neighbor , speed 10 , no auto-negotiation

can you share experience or advice these situations

 

 

 

 

7 REPLIES 7
Rising star

Re: disconnect device on switch

Hi, can you check the log of the switch (show logging)?

Can you check if the port go in blocking due to spanning tree (show spanning tree summary)?

 

Regards.

Participant

Re: disconnect device on switch

test with a minimal interface config

also try speed auto, duplex auto

could connect a test laptop to one of those same ports & check if it stays connected

regards, mk

Beginner

Re: disconnect device on switch

Hello
I tried speed auto and duplex auto, spanning tree
these devices connect to new 2960 switch and there is no config, the port is up but there is no ping
i check log but i didn't see anything
I am sure these devices never disconnect on dummy switch
VIP Advisor

Re: disconnect device on switch

Hello


@coskun sanli wrote:
Hello
I tried speed auto and duplex auto, spanning tree
these devices connect to new 2960 switch and there is no config, the port is up but there is no ping

Do these devices obtain ip address allocation via dhcp or are they statically assigned?

On the access ports do you have spanning-tree portfast enabled?


Could you try the following
default int x/x
int x/x

switchport host
power inline never
<if poe switch>
shut
no shut



kind regards
Paul

Please rate and mark posts accordingly if you have found any of the information provided useful.
It will hopefully assist others with similar issues in the future
Beginner

Re: disconnect device on switch

Hello Paul

spanning tree enable in global 

i tried power inline never  

now i use " switchport host "command and i am testing 

Beginner

Re: disconnect device on switch

Hello Paul

i used " switchport host "command 

but devices disconnected

Highlighted
Beginner

Re: disconnect device on switch

Hello Paul

i used " switchport host "command 

but devices disconnected

Everyone's tags (1)
CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards