05-16-2019 05:48 AM
I am using DMVPN with EIGRP and am able to connect to the remote site router and switch. the router at the remote site shows the router at the main site in EIGRP neighbors and at the remote site I am able to ping the devices attached to the switch from both the router and the switch. but from the main site if I run a traceroute I get to the router at the remote site and it stops.
Solved! Go to Solution.
05-16-2019 06:36 AM
Well it was a simple Fix power cycled the switch and it is up and running. not sure why rebooting it didn't do it.
Thank you
05-16-2019 06:05 AM
05-16-2019 06:16 AM
You checked local firewall on endpoints to allow ping from main subnet?
the subnets from the main site may not be properly published by eigrp neighbor to the remote site.
if so the remote router there cannot find the way back to the main subnet.
check output from show ip route and show ip eigrp topology.
05-16-2019 06:36 AM
Well it was a simple Fix power cycled the switch and it is up and running. not sure why rebooting it didn't do it.
Thank you
05-16-2019 06:43 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide